This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pro2Plus Parts List R18 and R19
#1
Hi, just building the Pro2Plus Rx 2.00 and see there are two resistors marked R18 and R19 with an asterisk in the parts list but can see no explanation of what the asterisk is meant to signify. I can see them labelled on the circuit board below the RTC connector but not installed in the picture of the circuit board and they are in the schematic as pull-up resistors for SDA_L and SCL_L. 

This has probably been answered before but I cannot find it. Please point me in the right direction.

Thanks Dave
Reply
#2
Hi Dave,

There is no need to install R18 and R19 as the RTC module already have pull-up resistors for the SDA / SCL lines.

Rgs.
Reply
#3
Thanks problem solved!

Dave Rolleyes
Reply




Users browsing this thread: 1 Guest(s)