This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Pro2 PLUS] Mega 2560 problem
#21
Despite the value shown on the schematic, all Pro2 PLUS boards were and are supplied with an 4 Ohms resistor at R1. Value is not very critical, it could be 4.3 Ohms, but not too high, or it will heat significantly and TFT brightness will lower.
Reply




Users browsing this thread: 1 Guest(s)