[werk_ag]

THIS GUIDE APPLIES TO RX BOARDS VERSIONS V4.0X

Board ---------> TFT
SCLK ---> SCK
MOSI ---> SDA
CS ---> CS
RST ---> RESET
DC ---> A0
5V ---> VCC
GND ---> GND
LED+ ---> LED+
LED- ---> LED-


Hint: On the RX pcb solder a row of 10 pin headers, then use 9 Dupond female to female wires to connect pcb pin headers to TFT pin headers. And that's it, in less than a minute TFT is connected.

[Live_Steam_Mad]

Thanks for the guide. I had some questions about it which I wrote and got replies for ;- http://www.meteocercal.info/forum/Thread...760#pid760 , I should have put them here but at least the info is available to all now.

Regards,

Alistair G.