Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Compile Error P2ESP8266_RX_v4.1_b001 AQI_Standard = 3
#1

Version: P2ESP8266_RX_v4.1_b001

Getting a compile error whenever i set the AQI_Standard to 3.  There is no problems compiling the code if AQI is set from 0 through to 2.


From Config_options.h
// --------------------------------------------------------------------------------------
//   If you have an WeatherDuino Air Quality Monitor the setting bellow MUST be defined
//   The value of this setting MUST match the value defined on the Air Quality Monitor device
// --------------------------------------------------------------------------------------
#define AQI_STANDARD   3   //  0= USA (AQI-EPA), 1= EUROPE (EAQI), 2= UK (DAQI), 3= AUSTRALIA (AQC - NSW)


Compile Log:

Arduino: 1.8.13 (Windows Store 1.8.42.0) (Windows 10), Board: "LOLIN(WEMOS) D1 R2 & mini, 80 MHz, Flash, Legacy (new can return nullptr), All SSL ciphers (most compatible), 4MB (FS:2MB OTA:~1019KB), v2 Lower Memory, Disabled, None, Only Sketch, 921600"


C:\Users\brett\Documents\Arduino\WeatherDuino_Pro2_Compact_v4.1_20201120\WeatherDuino_Pro2_Compact\software\RX software\WeatherDuino_P2ESP8266_RX_v4.1_b001\D_TFT.ino: In function 'void draw_AU_AQC(uint16_t)':
D_TFT:729:14: error: 'Display' was not declared in this scope
     aqi25  = Display.PM25AQI / 10;
              ^
exit status 1
'Display' was not declared in this scope


Thoughts?

   

Brett
Reply


Messages In This Thread
Compile Error P2ESP8266_RX_v4.1_b001 AQI_Standard = 3 - by bgedward - 30-12-2020, 07:41
RE: Compile Error P2ESP8266_RX_v4.1_b001 AQI_Standard = 3 - by Werk_AG - 30-12-2020, 20:29
RE: Compile Error P2ESP8266_RX_v4.1_b001 AQI_Standard = 3 - by bgedward - 31-12-2020, 12:40



Users browsing this thread: 1 Guest(s)