This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
AuriolDuino with Ventus831
#1
Hi, i would interface my all sensor (thermo/hygro,wind,rain) with a this board. Now i have the weather station base, and receive the data on my PC every 2 minute.
I don't have a Raspberry or Arduino board for interface that with internet server.
With this system(AuriolDuino) ,can i receive the data every sensor transmit,without original base station,but directly with RFM module of this board? On the manual ,sensor transmit with 433mHz.
Thanks
Saverio.
#2
I can't guarantee that the AuriolDuino works with Ventus W831. It was tested with the Ventus W155, and it works, but I don't know if the Ventus W831, despite it use the 433Mhz frequency, is also using the same data protocol.
MeteoCercal - Air Quality Data
Click here to watch at my ThingSpeak channel







Users browsing this thread: 1 Guest(s)